Vission 3000 Controller - Hardware

PSU Module

A single PSU module is fitted to each system to provide the voltage rails required by the CPU and all input and output cards.

The PSU module provides input supply surge protection and is fused to protect the module. The cleaned, surge protected high voltage supply is used to supply the 'Top Box'.

The PSU module is fitted with a switch mode power supply to enable the system to accommodate fluctuations in supply voltage.

Three front panel red LED's are used to indicate the correct operation of the +12V, -12V and +5V power supply rails.

Part Number: PCB-ASS-PSU

• Keyed connector to prevent incorrect installation
• Over-voltage protection
• Front panel indication of voltage supply rails

CPU Module

A single CPU module is fitted in each system to handle both the communications from the control box to the top box and to co-ordinate the signals from the various input and output modules.

A front panel red LED is fitted to indicate communications with the input and output modules.

Part Number: PCB-ASS-CPU

• Keyed connector to prevent incorrect installation
• Front panel indication of communication status

Thermocouple Module

The thermocouple module is capable of handling upto 16 sensor inputs. All inputs use differential circuitry to reduce noise and improve accuracy.

A front panel red LED is fitted to indicate when it is communicating with the CPU module.

Part Number: PCB-ASS-TC

• Keyed connector to prevent incorrect installation
• 16 sensor input
• Type J or K input

Dual Output Module

The Dual Output module contains two zones rated at 7.5 Amps at 50V ac., suitable for use with low voltage (24V) hot runner systems e.g. Plasthing, MoldMaster. Each output zone is fused with Fast Blow FF fuses.

Front panel leds indicate communication from the CPU module (red LED), output fuse operational for each zone (green LED) and output activity for each zone (red LED).

Part Number: PCB-ASS-OP2

• Keyed connector to prevent incorrect installation
• Front panel indication of communication status
• Front panel indication of fuse status

Quad Output Module

The Quad Output module contains four zones rated at 3.5 Amps at 240V ac. Each output zone is fused with Fast Blow FF fuses.

Front panel leds indicate communication from the CPU module (red LED), output fuse operational for each zone (green LED) and output activity for each zone (red LED).

Part Number: PCB-ASS-OP4

• Keyed connector to prevent incorrect installation
• Front panel indication of output status
• Front panel indication of fuse status
• Front panel mounted fuse holders